FX3 version 2.02 and FX30 version 1.02 firmware updates.

[alisterchapman]

Sony have now released new firmware updates for both the FX3 and FX30. The FX3 now goes to firmware version 2.02 and the FX30 to firmware version 1.02

These are mainly stability releases that fix some minor bugs, but if you have an FX3 on the original version 1 firmware then this version adds the CineEI mode and LUTs. It is a major update that is well worth having.

 

Before attempting to update the camera you should insert a fully charged battery

 

The FX3 is updated via a computer application. While there is a Mac application there can be some hoops to jump through to get it to work, so I would urge you to find a windows PC to do the update, it is far simpler and far more likely to be successful. The good news is that once you have updated to version 2.02 future updates can be done by uploading the update file to an SD card and initiating the update from the camera like the FX30.

 

The FX30 is updated by placing the downloaded BODYDATA.DAT file on to an SD card that was previously formatted in the camera. Then place the card in the camera and go down to the SETUP – SETUP OPTION – VERSION page of the menu. Here you should see the cameras current firmware version plus a “SOFTWARE UPDATE” button. Press (select) the software update button.

 

On the next page it will say “Update ?” and show the old firmware version and the new firmware version. Then just below this is a box where it says “Please follow these precautions until the very end”. 

 

What isn’t clear at this step is that you need to scroll down inside that box and read the full list of precautions before the camera will allow you to do the update.  

If you don’t scroll down and just press the “Execute” button you get a large popup telling you to “Follow the precautions to the very end” and pressing “OK” simply takes you will go back to the previous page. So do make sure you scroll down through the full list of precautions before you press execute. Once the update starts the screen will go blank, the only clue that the update is happening will be the slow flash of the media LED on the back of the camera. The update takes about 10 minutes to complete and the camera will reboot when it’s done.